immersion heater element technical features

- Mar 30, 2019-

1. Single-head electric heating tube The heating liquid in the single-head electric heating tube is generally a threaded single-head electric heating tube, which is often used to heat the water tank and the like.

 

The installation method of the threaded single-head electric heating pipe is as follows:

 

A. Drill a threaded hole in the water tank that matches the thread of the heating pipe.

 

B. Screw the liquid heating tube from the outside to the inside. (There is also a threaded single-headed heating tube with a threaded upward direction, the installation direction is opposite to it)

 

2, U-type / W-type / straight rod / shaped electric heating tube General heating liquid U-type / W-type electric heating tube are used with fasteners or silicone indenter.

 

A. Drill a hole slightly larger than the diameter of the pipe thread on the equipment where the electric heating pipe is installed.

 

B. Then pass the end with the fastener through the hole, put on the gasket or washer, and screw on the nut. The differences and main features of air heaters and liquid heaters are described in use.

 

3, flange electric heating pipe flange electric heating pipe installation method compared to the above several complex points.

 

There are many ways to install the liquid heating tube. According to the above, we should know how to install the liquid heating tube. The differences and main features of air heaters and liquid heaters are described in use.